Civil MDC

Pile Cap Design Calculations for CSI SAFE 2

Pile Cap Design Calculations for CSI SAFE

Deep Foundation: Footing Pile Cap Design A pile cap is one of the types of foundation that consist of a thick concrete pad that is usually supported by piles.
This is commonly used in building foundations with the geographical locations having a very low soil bearing capacity. Pile cap serves to transmit the load of the building into the hard strata of the soil via a pile or group of piles.

Design-wise, the pile cap design uses a truss system principle that can be designed using a strut and tie method. Designing a pile cap seems to be complicated because a lot of considerations need to take into account to achieve a safe and sound foundation. These considerations include the proper spacing of each pile, the pile cap thickness and so on. To achieve this can only be done by understanding its design principles and proper detailing of pile caps. The designer’s struggle on pile cap design begins with the consideration of what dimensions or pile cap geometry to assume at first. But knowing the correct pile cap dimensions can be considered as a halfway already in design completion.

In this article, we will be dealing with the standards in determining pile cap geometry and dimensions as well as its design considerations. To make it simple, we will break down our design assumption with the following. 1. Recommended Shape and Its Dimensions The first thing to consider in the pile cap design is to determine the shape of the pile cap to use. The shapes vary according to the number of piles in the pile cap that can be deriving according to the load in a column supporting it. The figure below shows the most common use shapes of the pile cap and the recommended dimensions. Corrections for the above image: for 2-Pile Group, length of the pile cap should be (?+1) x Øpile + 300 and for the 5-Pile Group, pile to pile spacing would be: s=?(2?) x Øpile 2. Recommended Thickness of Pile Cap One of the important things to consider in a pile cap design is to determine enough thickness. Pile cap thickness must also be sufficient to meet anchorage-bond length requirements of starter bars and normal punching shear requirements.

Here is how to assume the thickness of the pile cap: If diameter of pile < 550mm: thickness = 2 x diameter of pile If diameter of pile > 550mm: thickness = 1/3[(8 x diameter of pile)-600] 3. Punching Shear Check Punching shear along the column perimeter should be satisfied according to the standard codes. Also, punching shear due to piles should also be considered in the design check. Further details in punching shear design considerations will soon be published in the succeeding article. 4. Recommended Details Proper detailing of the pile cap is another thing to consider for design completion. Drawing details should be clear and simple as possible so the contractor can follow it accordingly. Refer to the image below for the recommended typical details of the pile cap.5. Pile Cap Design Approach There are so many ways to design a pile cap.

Technically, it can be designed manually using a principle of strut and tie method. But if you are considering a wide pile cap supported by multiple numbers of piles, computer-generated structural design soft wares are available to design a massive pile caps.The above design assumptions and recommendations are considered as guidelines in considering pile cap as your choice of foundation. Kindly bear in mind that at the end of the day, it is always the structural engineer’s decision and judgment will still follow depending on your guts and prerogative, but at least the above basic knowledge can help you dig in and explore pile cap designing.

Pile Cap Design Calculations for CSI SAFE 3

10 thoughts on “Pile Cap Design Calculations for CSI SAFE”


  2. First of all lwould like thank you your post.i need more structural analysis and design step by step thank you.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top