Design calculation is performed according to coal information and boiler parameters to determine fluidization velocity, bed material height (usually the height of the overflow port), and the air distributor area
DESIGN CALCULATION Read More »
corbel is a short cantilever projecting out from a column, a wall, or the side of a beam. … ACI 318 restricts the term “corbel” to a member having span-to-depth ratio which is less than or equal to 1.0. Corbels are widely used in precast concrete construction.
Corbel Design Based on IBC 06 / ACI 318-08 Read More »
Isolated footings are designed to sustain the applied loads, moments and forces and the induced reactions and to ensure that any settlement which may occur is as nearly uniform as possible, and the safe bearing capacity of the soil is not exceeded (see IS 1904)
DESIGN OF ISOLATED (S.Q & R.E) FOOTINGS Read More »
One-way slab action is assumed in a ribbed floor (slab with joist beams) made of the precast double-tee section, in the ribbed floor with integral beams, and also in hollow-block or hollow-cored slabs. Read more about the floor system of structure
DESIGN OF RIBS FOR ONE-WAY RIBBED SALB Read More »
A reinforced concrete column is said to be subjected to an axial load when the line of the resultant thrust of loads supported by the column is coincident with the line of C.G. of the column in the longitudinal direction.
DESIGN OF SHORT AXIALLY LOADED “RE” COLUMNS Read More »
A load calculation is the process of determining the proper size of a furnace and/or air conditioner for a home. In the early days of the industry, hvac companies made an educated guess to determine the heat gain and loss for the home.
The design of beam includes the estimation of cross section dimension and reinforcement area to resist applied loads. There are two approaches for the design of beams. Firstly, begin the design by selecting depth and width of the beam then compute reinforcement area.
The two-way slab is a slab which is generally supported on all sides of walls or beams, and whose length to breadth ratio is less than two and it twists or bends in both direction while transferring the loads to the walls or beams.
2-WAY SPANNING INSITU CONCRETE SLABS to EN 1992-1:2004 and standard tables Read More »
A stair flight is a run of stairs or steps between landings. A staircase or stairway is one or more flights of stairs leading from one floor to another, and includes landings, newel posts, handrails, balustrades and additional parts. Flight. It is a continuous series of steps in one direction,, separated by horizontal platforms or winders. Landing.
STAIR FLIGHTS AND LANDINGS to EN 1992-1: 2004 Read More »
In structural engineering, a shear wall is a vertical element of a system that is designed to resist in-plane lateral forces, typically wind and seismic loads. … A shear wall resists loads parallel to the plane of the wall. shear wall, In building construction, a rigid vertical diaphragm capable of transferring lateral forces from exterior walls, floors,
SHEAR WALL LOAD DISTRIBUTION to BS EN 1992-1: 2004 Read More »
