“CLIPCONN” — BEAM END CONNECTION USING CLIP ANGLES Program Description: “CLIPCONN” is a spreadsheet program written in MS-Excel for the purpose of analysis of steel beam endconnections using double clip angles either welded or bolted to the beam web, and bolted to either the columnflange, column web, or girder web. The connections may be subjected […]
BEAM END CONNECTION USING CLIP ANGLES Read More »
ABSTRACT: The provision of transverse openings in floor beams to facilitate thepassage of utility pipes and service ducts results not only in a more systematic layout ofpipes and ducts, it also translates into substantial economic savings in the construction ofa multi-storey building. To investigate the problem of openings in beams, the authorinitiated a research program
Check Reinforcement of WF Beam at Opening Read More »
Program Description: “BRGPLT9” is a spreadsheet program written in MS-Excel for the purpose of the analysis and design of beambearing plates. This program is applicable to beams supported on concrete walls, pilasters, and piers in anattempt to distribute the beam reaction over an area sufficient to keep the average bearing pressure withinacceptable limits. Specifically the
BEAM BEARING PLATE DESIGN Read More »
Bridges are the most important component of the transportation system of any country due to their ability of accelerating the development of the nation. Design of the bridge highly depends on its function, nature of soil strata where it is constructed and the material used to construct it. Extensive growth of population and traffic leads
DESIGN OF BOX BEAM Read More »
